I am pretty sure I have my switch correct. Assigned an IP to my workstation statically and cannot ping. Still can't pull an address from either DHCP Pool. Aside from using a dedicated tool (which.
Ditto on the EdgeRouter Lite being a great product. Lease reservations, DHCP migrations, etc. :!: (IMPORTANT: VLans NOT VLan host interface) :!: Failure to bond DHCP correctly will not work ! I set up 2 DHCP pools (10.10.10.0/24 and 20.20.20.0/24) and assigned each to the VLAN interface (NOT ether1) Assigned 10.10.10.1 to VLAN1 interface and 20.20.20.1 to VLAN2 interface. Rather than shutting down the DHCP server, why not just either temporarily disable the scope using the DHCP. Ditto on DHCP being handled on Server 2008 than a physical router. (If you have more then one VLANs (networks).You will need to setup Router on a Stick. Create the IP Pools, and DHCP server services and bind them to the seperate VLan interfaces. We have one VLAN and a router: In this lab: the Switch has only 1 VLAN and a router only. We also configure a DNS server in this example - clients connecting to our DHCP server will use the server 8.8.8.8 for performing domain name resolution. I created 2 VLANs (1 and 2) and they are both assigned to Ether1 (LAN of MT) Is this correct? The default-router value of 10.0.0.1 is the IP address clients will automatically configure as their next-hop IP address.
As expected R2 responds with the IP address on its FastEthernet interface. Create the VLan(s) on the MikroTik and specify the interface hooked to the uplink port as the "VLan Host" for each VLan. Let’s configure these IP addresses first: Before we dive into the NAT configuration let’s do a trace and look at the output: R1traceroute 192.168.12.2 Type escape sequence to abort. Router(config-if)ip helper-address 172.16.20.2 DHCP broadcasts will be forwarded as a unicast to this specific address rather than be dropped by the router. You mean on the switch? VLAN1 is ports 1,2 and 25 (25 is the uplink) VLAN2 is ports 3,4 and 25 (Again 25 is the uplink to the MT) Router(config)interface fastethernet 0/0 Moves to interface configuration mode.
The ports must be asigned to the seperate vlans. You must set up the uplink port as a member of both vlans.